Fort Worth Heating and Air Conditioning for Busy Households
We serve Fort Worth from our Cleburne base. Texas Heat & Air is a family-owned shop at 104 Vantage Dr, Suite B, Cleburne, TX 76031, founded in 2013 and licensed under Texas A/C contractor license TACLB00051450E. Fort Worth is a large city, so coverage here is confirmed by address: call (682) 438-8127 with your address and we will confirm coverage before you book.
Fort Worth homes span more than a century of building in one city, from older houses near the center to subdivisions that are still new. That range is the story of HVAC work here. One street needs a furnace and ductwork checked together, and the next needs a first system replaced in a home built in the 2000s.
Services in Fort Worth
- AC Repair: diagnosis and repair when a Fort Worth system will not cool, blows warm air or will not start.
- AC Installation & Replacement: new systems sized to your home, for older houses and newer subdivisions alike, with free estimates for new installations and complete replacements.
- Heating & Heat Pump Repair: gas furnaces, electric furnaces and heat pumps, including auxiliary heat and defrost problems.
- Urgent AC & Heating Problems: how to reach us for no-cool, no-heat and safety problems outside office hours, with after-hours rates and availability explained plainly.
- Maintenance & all HVAC services: seasonal tune-ups that catch a weak part before the hottest or coldest week of the year.
Based in Cleburne: our office is at 104 Vantage Dr, Suite B, Cleburne, TX 76031, and Fort Worth is served from that shop. See our Cleburne hub, our Burleson page and our Granbury page for the neighboring service areas, or the full list at which cities does Texas Heat & Air serve? Texas Heat & Air is a family-owned contractor holding Texas A/C contractor license TACLB00051450E, issued by TDLR. Office hours are Monday to Friday, 8:00 AM to 5:00 PM.
Fort Worth Homes: Old and New at the Same Time
Fort Worth has 373,948 homes, and its housing stock pulls in two directions at once. About 46.4% of homes were built before 1990, while 43.4% were built in 2000 or later, and the median home was built in 1994. Few cities carry that much older housing and that much new housing at the same time, and it shows up in the service calls.
In an older home, we look at the ducts, the attic and the equipment together, because a new unit on tired ductwork still cools poorly and heats unevenly. In a newer home, the equipment is often on its first or second system, and the question is more often whether a single failed part is worth repairing or the system as a whole has aged out. About 57.0% of Fort Worth homes are owner-occupied, and the rest are rentals, so we also keep the written estimate clear enough to share with a landlord or a family member who is helping with the decision.
| Built | Share of homes |
|---|---|
| Before 1990 | 46.4% |
| 1990 to 2009 | 30.5% |
| 2010 or later | 23.1% |
In words: 46.4% of Fort Worth’s 373,948 homes were built before 1990, 30.5% between 1990 and 2009, and 23.1% in 2010 or later; the median Fort Worth home was built in 1994, and 57.0% of homes are owner-occupied. Source: U.S. Census Bureau, American Community Survey 2020 to 2024 (tables B25034 and B25035). Shares are rounded.
Fort Worth Permit Rules, in Plain Words
Fort Worth requires a mechanical permit for changing, moving or repairing mechanical equipment such as a central heating and air conditioning system, its duct work, and exhaust fans. Anyone pulling a permit for that work must have a valid Contractor Registration on file with the Development Services Department, and a Mechanical Contractor Registration requires a valid State of Texas air conditioning and refrigeration license with the proper endorsements. A homeowner working on a single-family home they own and live in is an exception to the registration rule.
Heating and cooling work here follows the Fort Worth Mechanical Code, which is the 2021 International Mechanical Code with local amendments, adopted by Ordinance 25384-03-2022 and effective April 1, 2022. Sources: City of Fort Worth Development Services, Contractor Registration and Residential Permit Guide; City Code Section 7-166. Last checked November 19, 2026. Rules change, so confirm with the City of Fort Worth before work starts.
Who Sends Your Electric Bill in Fort Worth?
For most Fort Worth addresses, Oncor delivers the electricity over its lines and handles outages, and you choose your own retail electric provider and plan. Some Fort Worth addresses are outside retail choice and are served by an electric cooperative instead, including Tri-County Electric Cooperative, which serves members in parts of the Fort Worth area and has an office in Fort Worth. At a cooperative address you start service with the cooperative, and there is no retail plan to choose. City limits and ZIP codes do not settle which one serves a house, so check your bill or ask the cooperative about the full address.
Natural gas is supplied by Atmos Energy where gas service is present, so many Fort Worth homes heat with a gas furnace, while homes without a gas line, including many newer all-electric homes, usually heat with electricity or a heat pump. Knowing which electric provider serves your address matters before a replacement, because it decides who you call about power and whether any provider program could apply.
Frequently Asked Questions
Do you serve my part of Fort Worth?
Call (682) 438-8127 with your address and we will confirm coverage before you book. Fort Worth is a large city and it is served from our Cleburne shop, so coverage is confirmed by address rather than assumed from the city name alone.
Where are you based, and how do I reach you?
Our shop is at 104 Vantage Dr, Suite B, Cleburne, TX 76031, and Fort Worth is served from there. Call (682) 438-8127 or request service online. Office hours are Monday to Friday, 8:00 AM to 5:00 PM.
My Fort Worth home was built before 1990. What should I check?
Have the age of the outdoor unit, the ductwork and the attic insulation looked at together. About 46.4% of Fort Worth homes were built before 1990, so many still run older ducts or older equipment. Start with AC repair in Fort Worth for a diagnosis, and we will tell you plainly if the ducts or the unit are the real problem.
Do I need a permit to replace my AC in Fort Worth?
Yes, for changing, moving or repairing a central heating and air system or its ductwork. Only a contractor registered with the City of Fort Worth can pull that permit, and mechanical contractors must hold a valid Texas air conditioning and refrigeration license. Rules change, so confirm the current requirement with the City of Fort Worth before work starts.
Which electric company serves my Fort Worth home?
Most Fort Worth addresses are on Oncor’s lines, and you choose your retail electric provider. Some addresses are served by Tri-County Electric Cooperative instead, where you start service with the cooperative and do not choose a retail plan. Check your bill to see which one you have, because it decides who you call about an outage and whether any cooperative program could apply to a new system.
Gas furnace or heat pump: which makes sense in Fort Worth?
Both are common here. Atmos Energy supplies natural gas where gas service is present, so a gas furnace is an option in homes with a gas line. Homes without gas, including many newer all-electric homes, usually use a heat pump or electric heat. We can look at your home and walk you through both.
My AC is blowing warm air. Where do I start?
Start with AC repair in Fort Worth and the two safe checks there: the thermostat and the filter. If the system still blows warm, a technician needs to test it, because the likely causes are electrical or refrigerant problems. Call (682) 438-8127 with your address and we will confirm coverage before you book.
Need HVAC Service?
Call Texas Heat & Air for service availability.