Air Conditioner Repair for Burleson Homes
Burleson grew in subdivisions, and a lot of those homes are still running the system the builder put in, or one just like it. At 12 to 20 years old, those systems start failing in predictable ways: warm air on the hottest week, a fan that will not start, a drain line that backs up. Texas Heat & Air diagnoses and repairs air conditioners in Burleson homes.
Call (682) 438-8127 with your address and we will confirm coverage before you book. We are a family-owned contractor based at 104 Vantage Dr, Suite B, in Cleburne, and our Texas A/C contractor license is TACLB00051450E.
Our promise: We find the problem, explain your options in plain terms, and give you the repair price in writing, and no work starts until you approve it.
Common Problems We Fix
- The system runs but blows warm air
- Weak airflow or frozen coils
- The outdoor unit will not start, or the fan will not spin (capacitor, contactor, motor)
- Refrigerant leaks. We find the leak before we recommend a recharge.
- Thermostat and control faults
- Water leaking from the indoor unit or a clogged condensate drain
What Is Your AC Doing? Start Here
Find your symptom below. The two checks anyone can do safely are the thermostat and the air filter. Anything involving electrical parts, refrigerant or opening the equipment is a job for a licensed technician.
Running but not cooling, or blowing warm air
Safe checks: Make sure the thermostat is set to Cool and set a few degrees below the room temperature, and check the filter. A clogged filter chokes airflow and can stop a system from cooling. Call us if it still blows warm after those checks. On an aging first system, low refrigerant, a refrigerant leak or a failing compressor are all common causes, and only a technician can test for them safely.
Prefer to read up first? Our diagnostic guide explains why your air conditioner is not cooling, and two common versions get their own walk-throughs: an AC that is running but not cooling, and one that is blowing warm air.
Weak airflow from the vents
Safe checks: Replace or clean a dirty filter and make sure supply vents are open and not blocked by furniture, which matters in two-story Burleson homes where upstairs vents are easy to close off and forget. Call us if airflow stays weak. The cause can be a tired blower, a frozen coil or a duct problem.
Water leaking indoors
Safe check: Turn the system off at the thermostat so the leak does not damage ceilings, walls or flooring. The usual cause is a clogged condensate drain line. Call us to clear the drain and check for damage, and call right away if water is reaching ceilings or walls.
Strange noises, such as grinding, squealing, banging or hissing
Safe check: Turn the system off at the thermostat. Grinding or squealing can get worse fast and damage the motor or compressor. Call us. Noises like these point to electrical or refrigerant problems that are not safe to open up yourself.
Short cycling, turning on and off every few minutes
Safe checks: A clogged filter can cause this, so check the filter first, and make sure the thermostat is not in direct sun or next to a heat source. Call us if it keeps cycling. Short cycling wears out the compressor and can signal a refrigerant or control problem, and it is one of the ways an older system announces that it is near the end.
Frozen lines or ice on the coil
Safe checks: Turn the cooling off and set the fan to On so the ice can thaw, then check the filter. Restricted airflow is a common cause. Never chip at the ice or try to add refrigerant. Call us if it freezes again after thawing; repeat freezing usually means low refrigerant or an airflow fault a technician needs to find.
Outdoor unit will not start, or thermostat screen is blank
Safe checks: If your thermostat runs on batteries, fresh batteries fix many blank screens, and confirm it is set to Cool with the set temperature below the room temperature. For the outdoor unit, leave it alone. Never push the fan with a stick or tool, even if the top looks still. Call us if the screen stays blank or the unit will not start. A non-starting unit is often an electrical part such as a capacitor, contactor or motor, and these parts store an electrical charge and are dangerous to handle. Do not open thermostat wiring yourself.
If a safe check does not solve it, call (682) 438-8127 with your address and we will confirm coverage before you book, or request service online. If the system is completely out after hours, see our urgent AC and heating problems page for how to reach us.
How a Repair Visit Works
- Call (682) 438-8127 with your address, or request service online, and we will confirm coverage before you book.
- A technician diagnoses the system and explains the cause.
- You get your repair options and the repair price in writing, before any work starts.
- You approve the written estimate, or, if replacement makes more sense, we show you both options and the cost of each and you decide.
Brands: We service all major brands.
Licensed and based nearby: Texas Heat & Air holds Texas A/C contractor license TACLB00051450E, issued by TDLR. Our office is at 104 Vantage Dr, Suite B, Cleburne, TX 76031, and Burleson is north of our shop on TX-174 and Chisholm Trail Parkway. Call (682) 438-8127 with your address and we will confirm coverage before you book.
Frequently Asked Questions
How fast can you come out?
It depends on the season and the day’s schedule. Call (682) 438-8127 for current availability.
Should I repair or replace?
We will show you both options and the cost of each, so you can decide what makes sense for your home. In Burleson that question often comes up with an original system from the 2000s, and we will be plain about the age of the equipment either way.
Are you licensed?
Yes. Texas A/C contractor license TACLB00051450E, issued by TDLR. You can verify it at tdlr.texas.gov.
Do you charge for a diagnosis?
Call (682) 438-8127 and we will explain any charges that apply before you book.
What should I check before calling for AC repair?
Two safe checks: the thermostat (set to Cool, below room temperature, fresh batteries if it uses them) and the air filter (replace it if it is clogged). If the system still does not cool after that, call (682) 438-8127 with your address and we will confirm coverage before you book. The cause is likely electrical or refrigerant-related and needs a technician.
Why is my AC running but not cooling?
Common causes are a clogged filter, low refrigerant or a leak, and failing electrical parts, all common as a first system ages. Start with the thermostat and filter checks above; if it still blows warm, a technician needs to test the system. We find a leak before recommending a recharge.
Related Services in Burleson
If your Burleson system is an original from the 2000s, a repair visit may also be the right time to price a replacement. See AC installation and replacement. Heating trouble instead? We handle heating and heat pump repair. For a complete picture of what we do in this city, visit the Burleson HVAC hub.
Need HVAC Service?
Call Texas Heat & Air for service availability.