New AC System Installation for Keene Homes
In Keene, a replacement is rarely a simple swap. The median home here was built in 1985, so a new system usually goes into a house with older ducts, an attic air handler, and access that was not designed for today’s equipment. We size the equipment to your home rather than to the old unit, check the ductwork and attic access as part of the assessment, and explain efficiency choices in plain terms.
That extra look matters. A right sized, efficient unit connected to leaking ducts will still leave a Keene home uneven and expensive to cool, and we would rather tell you that before the install than after.
What’s Included
- In home assessment and written quote, with free estimates for new system installations and complete replacements
- Equipment sizing based on your home, not a copy of the old unit’s size
- Ductwork, attic access, and condensate setup checked during the assessment, which Keene’s older homes need
- Permit obtained before replacement work, as Keene’s Section 105.1 requires
- Efficiency (SEER2) options explained in plain terms before you choose
Repair or Replace? How to Decide
Not every failing system needs to be replaced. Replacement is usually worth pricing when the system is older, uses R-22 refrigerant, or faces a major repair such as a compressor. We will show you both options and the cost of each, so you can decide what makes sense for your home, and if a repair is the smarter spend, we will say so. Start with a diagnosis on our AC repair page for Keene. Our written framework for the same decision is Repair or Replace? A Homeowner’s Decision Framework.
One Keene specific note: do not judge by the house. A 1980s Keene home may run a 2016 system with years left in it, while its neighbor runs a unit from the early 2000s that is living on borrowed time. We read the data plate, check the ducts, and price the decision on the equipment you actually have.
What efficiency (SEER2) means for your bill
SEER2 is the current efficiency rating for cooling equipment: the higher the number, the less electricity the system uses to deliver the same cooling. Sizing matters just as much. An oversized system short cycles and leaves humidity behind, and an undersized one runs all day. In Keene, duct condition matters almost as much as the rating on the box, because cooled air lost in the attic never reaches your rooms at any efficiency. For the bigger picture, see our guide to buying a new HVAC system and the companion checklist on what matters most when buying a new HVAC system.
Your electric provider also belongs in this conversation. Keene homes split between Oncor and United Cooperative Services, and any efficiency program or rebate comes from your provider, on its own terms. Check your bill, confirm the current offers yourself, and we will size and quote the system either way.
How an installation works
Keene’s code sets a few local details we plan around from the first visit, including the permit, the attic access opening, and the condensate rules for equipment above living space.
- Assessment and sizing: we visit your home, size the system to the house, and check the ducts, attic access, and drain setup.
- Written quote: for new system installations and complete replacements, with the timeline spelled out before any work begins.
- Permit and installation: we obtain the Keene permit first, then install the equipment we quoted.
Permits for a replacement in Keene
Section 105.1 of Keene’s Combined Amendments to the 2018 I-Codes requires a permit before a mechanical system is replaced. Applications go through City Hall in person, online at keenetx.com, or by email to [email protected]. Keene builds to the 2018 I-Codes with regional amendments, and its amendments also set a minimum attic access opening of 20 inches by 30 inches and the condensate rules we follow on attic installs. We handle the permit as part of the installation, and you can confirm the current rules with the City of Keene.
Frequently Asked Questions
How long does an install take?
It depends on the scope of the job. Older Keene homes can add duct or access work to a straightforward swap. We will give you a timeline with your written quote before any work begins.
What brands do you install?
We install major brands and recommend the equipment that fits your home and budget, including systems for manufactured homes.
Do you offer estimates?
Yes. Estimates for new system installations and complete replacements are free. Call (682) 438-8127 with your Keene address and we will confirm coverage before you book.
Should I repair or replace my AC?
Replacement is usually worth pricing when the system is older, uses R-22 refrigerant, or needs a major part like a compressor. We will show you the repair and replacement costs side by side so you can decide. See our AC repair page for Keene if you want a diagnosis first.
What size AC does my home need?
It depends on your home, not on the size of the unit being replaced. We size the new system to your home during the in home assessment, which protects comfort and efficiency. In Keene we also check whether the existing ducts can carry the air the new system moves, because older ductwork often cannot.
Need HVAC Service?
Call Texas Heat & Air for service availability.