Installing New AC and Heat Pump Systems in Granbury
Replacing an HVAC system is one of the biggest purchases a homeowner makes. We size the equipment to your home rather than to the old unit, and we explain efficiency (SEER2) choices in plain terms. That sizing conversation looks different across Granbury: an older in-town home may need its ductwork assessed first, a newer subdivision home usually needs a straight comparison of repair against replacement, and a lake home needs a system that handles long idle stretches and humid weekends without trouble.
Call (682) 438-8127 with your Granbury address and we will confirm coverage before you book. Texas Heat & Air is family-owned, based at 104 Vantage Dr, Suite B, Cleburne, TX 76031, and licensed under TACLB00051450E.
What’s Included
- Free estimates for new system installations and complete replacements, with an in-home assessment and a written quote
- Equipment sizing for your home, not a copy of the old unit’s size
- A plain-language walk-through of efficiency (SEER2) choices and what each one means for your electric bill
- Ductwork checked on older homes, so a new system is not paired with ducts that cannot move the air
- Permit and inspection handled under Granbury’s rules, with only city-registered contractors pulling permits
- For lake homes and second homes, a start-up check of the drain line and controls before the season begins
Repair or Replace? How to Decide
Not every failing system needs to be replaced. Replacement is usually worth pricing when the system is older, uses R-22 refrigerant, or faces a major repair such as a compressor. We will show you both options and the cost of each, so you can decide what makes sense for your home, and if a repair is the smarter spend, we will say so. Start with a diagnosis on our AC repair page. Our written framework for the same call is Repair or Replace? A Homeowner’s Decision Framework.
In Granbury, one extra question belongs in that decision: how is the house used? A system in a home lived in year round earns its keep every day. A system in a weekend home may have low hours but a hard life of sitting idle, then running flat out on a hot Friday evening. Both facts belong in the repair or replace conversation, and we will ask about them.
What efficiency (SEER2) means for your bill
SEER2 is the current efficiency rating for cooling equipment: the higher the number, the less electricity the system uses to deliver the same cooling. In Granbury, who provides your electricity matters too. City customers are on the City of Granbury’s own utility, while some addresses around town are United Cooperative Services members, and United lists heat-pump rebates that can change the math on a higher-efficiency system. Confirm any rebate with your provider before you buy.
Sizing matters just as much. An oversized system short-cycles and leaves humidity behind, which is a real comfort problem in homes near the lake, and an undersized one runs all day. That is why every quote starts with sizing the system to your home. For the bigger picture, see our guide to buying a new HVAC system and the companion checklist on what matters most when buying a new HVAC system.
How an installation works
The steps are the same whether the home is an older house in town, a newer subdivision home or a lake house that needs access arranged ahead of time.
- Assessment and sizing: we visit your home, size the system to the house and talk through your options.
- Written quote: for new system installations and complete replacements, with the timeline spelled out before any work begins.
- Installation: we install the equipment we quoted, pull the Granbury permit as a city-registered contractor, and have the work inspected before the job is closed out.
Installing in a second home
If the home sits empty during the week, tell us before the assessment. We can talk through thermostat settings for an empty house, a safe winter setback instead of turning the system off, and a spring start-up check so the first hot weekend does not start with a service call. Questions about timing outside office hours? See urgent AC and heating problems in Granbury, or browse everything we do here on the Granbury HVAC hub.
Frequently Asked Questions
How long does an install take?
It depends on the scope of the job. We will give you a timeline with your written quote before any work begins.
What brands do you install?
We install major brands and recommend the equipment that fits your home and how you use it, whether that is a year-round home or a lake house.
Do you offer estimates?
Yes. Estimates for new system installations and complete replacements are free. Estimates are not free for repairs or diagnostics, so call (682) 438-8127 and we will explain what applies to your job before you book.
Should I repair or replace my AC?
Replacement is usually worth pricing when the system is older, uses R-22 refrigerant, or needs a major part like a compressor. We will show you the repair and replacement costs side by side so you can decide. See our AC repair page if you want a diagnosis first.
What size AC does my home need?
It depends on your home, not on the size of the unit being replaced. We size the new system to your home during the in-home assessment, which protects comfort and efficiency. In an older Granbury home, that assessment includes the ductwork, because ducts sized for an earlier system can limit a new one.
Need HVAC Service?
Call Texas Heat & Air for service availability.